5. Using Lredir

5.1. how do you use it?

Mount your dos hard disk partition as a Linux subdirectory. For example, you could create a directory in Linux such as /dos (mkdir -m 755 /dos) and add a line like

/dev/hda1 /dos msdos umask=022

to your /etc/fstab. (In this example, the hard disk is mounted read- only. You may want to mount it read/write by replacing "022" with "000" and using the -m 777 option with mkdir). Now mount /dos. Now you can add a line like

lredir d: linux\fs/dos

to the AUTOEXEC.BAT file in your hdimage (but see the comments below). On a multi-user system you may want to use

lredir d: linux\fs\${home}

where "home" is the name of an environmental variable that contains the location of the dos directory (/dos in this example)

You may even redirect to a NFS mounted volume on a remote machine with a /etc/fstab entry like this

otherhost: /dos nfs nolock

Note that the nolock> option might be needed for 2.2.x kernels, because apparently the locks do not propagate fast enough and DOSEMU's (MFS code) share emulation will fail (seeing a lock on its own files).

In addition, you may want to have your native DOS partion as C: under dosemu. To reach this aim you also can use Lredir to turn off the 'virtual' hdimage and switch on the real drive C: such as this:

Assuming you have a c:\dosemu directory on both drives (the virtual and the real one) and have mounted your DOS partition as /dosc, you then should have the following files on the virtual drive:

autoexec.bat:

lredir z: linux\fs\dosc copy c:\dosemu\auto2.bat z:\dosemu\auto2.bat lredir del z: c:\dosemu\auto2.bat

dosemu\auto2.bat:

lredir c: linux\fs\dosc rem further autoexec stuff

To make the reason clear why the batch file (not necessaryly autoexec.bat) must be identical:

Command.com, which interpretes the batchfile keeps a position pointer (byte offset) to find the next line within this file. It opens/closes the batchfile for every new batchline it reads from it. If the batchfile in which the 'lredir c: ...' happens is on c:, then command.com suddenly reads the next line from the batchfile of that newly 'redired' drive. ... you see what is meant?

5.2. Other alternatives using Lredir

To have a redirected drive available at time of config.sys you may either use emufs.sys such as

device=c:\emufs.sys /dosc

or make use of the install instruction of config.sys (but not both) such as

install=c:\lredir.exe c: linux\fs\dosc

The later has the advantage, that you are on your native C: from the beginning, but, as with autoexec.bat, both config.sys must be identical.

For information on using 'lredired' drives as a 'user' (ie having the right permissions), please look at the section on Running dosemu as a normal user.